F3-12800CL9D-4GBNQ | F3-12800cl7d-4gbrm | asus m4a79xtd evo

[Lord Mirko]

These are the following error i got before i did Prime95 in win

----------------------------------------------
1 long continues beep

dram refresh failure i think thats the problem in all of this
after i solved that with clr cmos to default
patch the bios again if it was corrupted


set it back to the values above, everything good


---------------------------------

now i wanted to test prime95

1. i tested in win i did not do Windows experience index and prime used only 3.4 gb and did good for 30 min then i stopped it -->restarded
2. did win index refresh restarted did prime again crash after 3 second everytime

first it was IRQL_NOT_LESS_OR_EQUAL - which is standard crash
second time it was this




P.S didnt do any overclocking

P.S.S - in ubuntu everything runs fine did not do any stress test in ubuntu, also did check win 7 for any errors packages files corruption and no errors i also have rescue disk which i cross checked with win 7 no errors so it is the ram refresh failure - i think

[Lord Mirko]

prime95 crashes also ubuntu

fffffffffffffffffffffffffffffffffffffffffffffffff

any suggestions

[Tradesman]

What are your current voltage, cpu and dram settings - from the BIOS?

[Lord Mirko]

1333 8-8-8-24 1.50v

cpu-nb 1.15v

[Tradesman]

GSkill should be back in Monday, as I offered earlier, don't think your CPU can handle 16/1600 and yes 1.9 for DRAM is above safety level, need to lower DRAM voltage and possibly increase CPU/NB ....as talked about earlier

[Lord Mirko]

1333 8-8-8-24 1.50v

cpu-nb 1.15v

im still at these settings memetest 5 passes no error

still it crashes in win 7 and frezes in ubuntu

i instaled win on another partition to make sure, still same bsod memory managment

[Tradesman]

CPU/NB up to about 1.2

[Lord Mirko]

i tryeed 1.30 still the same and everything below

[Tradesman]

May want to wait for GSkill, I forgot about Monday being a Holiday, they should be back Tues, will drop them a line to take a look at this thread

[Lord Mirko]

Ok.Thanks.

[GSKILL TECH]

Try raising DRAM Bus Voltage instead. CPU-NB Voltage should be fine at 1.10V or 1.15V. That does not need to change.

Thank you
GSKILL TECH

[Lord Mirko]

i hade it back at 8-8-8-24 cpunb 1.3 and dram 1.64 still unstable, any suggestions

[Lord Mirko]

bump bump bump

[GSKILL TECH]

What frequency? CPU-NB Voltage 1.30V is high for DDR3-1333. 1.64V is high too.

Thank you
GSKILL TECH

[Lord Mirko]

1333 8-8-8-24 cpunb 1.1-1.3 and dram 1.5-1.66 still unstable, any suggestions