I started the process of building a new PC this fall. Have been planning on picking up one of the new 30 series NVidia cards and waiting on hearing about the next gen AMD CPUs before finishing everything, so I picked up a 3400g to hold me over. Building an sffpc, so I put it in an asus rog strix x570-i motherboard. Even if the next gen CPUs don't impress me enough (or take too long) I'll fall back to a 3900x/3950x, so I figured I'd pair it with 3600cl16 ram.
Now I'm trying to get the current setup stable, and even though it's a zen+, I figured I should at least be able to get 3400, or maybe 3200 mhz out of it, but I'm struggling to get it to run error free even at 2933mhz (which I believe both the apu and board are easily rated for).
Using the XMP doesn't boot. Using the XMP and manually setting it down to 3400 boots, but almost instantly gets errors on memtest or tm5. 3200 runs for a bit longer before hitting errors.
The XMP sets the DDR voltage up to 1.35, and for some reason the motherboard doesn't let me set it any higher. On auto, the motherboard sets the SOC to 1.15. Based on DRAM Calculator, I tried bumping this down to 1.015, 1.025, and I even tried bumping it up to 1.15675, all still encountering errors. I've tried ProcODT of 68.6, 60, and lower to no success (and the board on auto runs it at 80). I've tried setting tCL all the way up to 24, still no go (XMP sets it to 16-19-19-39). I've got CLDO VPP at .900, and .950, still errors.
Leaving everything on "Auto" runs it at 2133, 15-15-15-36, and everything seems to run just fine for quite some time.
Any suggestions on what could be going wrong?
Now I'm trying to get the current setup stable, and even though it's a zen+, I figured I should at least be able to get 3400, or maybe 3200 mhz out of it, but I'm struggling to get it to run error free even at 2933mhz (which I believe both the apu and board are easily rated for).
Using the XMP doesn't boot. Using the XMP and manually setting it down to 3400 boots, but almost instantly gets errors on memtest or tm5. 3200 runs for a bit longer before hitting errors.
The XMP sets the DDR voltage up to 1.35, and for some reason the motherboard doesn't let me set it any higher. On auto, the motherboard sets the SOC to 1.15. Based on DRAM Calculator, I tried bumping this down to 1.015, 1.025, and I even tried bumping it up to 1.15675, all still encountering errors. I've tried ProcODT of 68.6, 60, and lower to no success (and the board on auto runs it at 80). I've tried setting tCL all the way up to 24, still no go (XMP sets it to 16-19-19-39). I've got CLDO VPP at .900, and .950, still errors.
Leaving everything on "Auto" runs it at 2133, 15-15-15-36, and everything seems to run just fine for quite some time.
Any suggestions on what could be going wrong?
Comment