I am trying to upgrade firmware 1916 to 2030. I have booted off the supplied WinPE disk. But when I try to run 64GB-1.exe, I get "The system cannot find the file 64GB-1.exe".
I can dir and its there. I can copy it to a new name, so I am definitely typing the correct file name. However, as soon as I try to run it, I get that error like the file is not there.
Tried 64GB-2.exe, 128GB-1.exe etc, all same.
Created my own WinPE boot USB ensuring those files were on that same USB, same.
Have tried a number of bios changes re SATA setup, same.
Per some other posts have set it to be SATA disk 0, removed all other drives, CDs etc, same.
I can run the file within windows 7 and it runs ok, but says no gskill disk found.
Tried to run from within safe mode, but can't get that far having changed SATA setting to IDE from normal AHCI.
The gskill is my boot disk. I have cloned to another drive and booted from that. Same. Can't set sata to IDE mode though per instructions. If I do, neither original or cloned one will boot.
Tried cloning to a USB drive but it won't work fully, starts loading windows then crashes.
The cloning issue is just info on what I've tried. Back to WinPE. Thats what this forum says I should do. Take that ISO, make a CD, boot from it, at the commandline run 64GB-1.exe (yes I have a 64GB SSD).
What am I doing wrong???
I can dir and its there. I can copy it to a new name, so I am definitely typing the correct file name. However, as soon as I try to run it, I get that error like the file is not there.
Tried 64GB-2.exe, 128GB-1.exe etc, all same.
Created my own WinPE boot USB ensuring those files were on that same USB, same.
Have tried a number of bios changes re SATA setup, same.
Per some other posts have set it to be SATA disk 0, removed all other drives, CDs etc, same.
I can run the file within windows 7 and it runs ok, but says no gskill disk found.
Tried to run from within safe mode, but can't get that far having changed SATA setting to IDE from normal AHCI.
The gskill is my boot disk. I have cloned to another drive and booted from that. Same. Can't set sata to IDE mode though per instructions. If I do, neither original or cloned one will boot.
Tried cloning to a USB drive but it won't work fully, starts loading windows then crashes.
The cloning issue is just info on what I've tried. Back to WinPE. Thats what this forum says I should do. Take that ISO, make a CD, boot from it, at the commandline run 64GB-1.exe (yes I have a 64GB SSD).
What am I doing wrong???
Comment