hi i have asus m4a78lt-m le motherboard and i bought gskill sniper 12800cl7d 2*4gb kit
i have athlon x4 640 3.0 overclock 3.6 240*15 and 1.280voltage
After installation of the ram their frequency was 1066mhz than i change voltage to 1.6 and memclock value to 800mhz. And now it works @1600mhz.
But now cpu-z shows this values
cl 9
trcd 9
trp 9
tras 28
trc 37
cr 1t
When i try to change this values from bios i changed dram timing mode to DCT0
then changed tcl 7 trcd 8 trp 7 TRAS 24. But when i try to save and exit from bios computers fans began to work faster but computer was not starting. Then i turned off its power and turned on again it error over voltage overclocking press f1 to setup
I changed DRam Timing Mode Auto and it works again but cl values not set 7-8-7-24 like i wrote up.
Sorry for my bad english what should i do?
i have athlon x4 640 3.0 overclock 3.6 240*15 and 1.280voltage
After installation of the ram their frequency was 1066mhz than i change voltage to 1.6 and memclock value to 800mhz. And now it works @1600mhz.
But now cpu-z shows this values
cl 9
trcd 9
trp 9
tras 28
trc 37
cr 1t
When i try to change this values from bios i changed dram timing mode to DCT0
then changed tcl 7 trcd 8 trp 7 TRAS 24. But when i try to save and exit from bios computers fans began to work faster but computer was not starting. Then i turned off its power and turned on again it error over voltage overclocking press f1 to setup
I changed DRam Timing Mode Auto and it works again but cl values not set 7-8-7-24 like i wrote up.
Sorry for my bad english what should i do?
Comment