Is this the correct settings for this memory

[bayourebel]

Are these the correst settings I need to make to get this ram G.SKILL Ripjaws 240-Pin DDR3 DDR3 1600 (PC3 12800) Model F3-12800CL9D-4GBRL to work in this mobo
ASUS M4A89GTD PRO AM3 AMD 890GX at 1600 mhz ? I have done some looking on this forum and saw a post with these settings. My cpu is a amd phenom II 550 unlocked to quad c3 revision if that matters. Thanks

Ai Overclock Tuner - Manual
DRAM Frequency - DDR3-1600
DRAM Timing Configuration (submenu)
CAS Latency 8
RAS to CAS 8
RAS PRE Time 8
RAS ACT Time 24
CPU/NB Offset Voltage +0.1V
DRAM Voltage 1.60V

Also does anyone know how I can get a G.Skill sticker or badge for my case ?

[Tradesman]

You can try it at those timings, though the spec timings are 9-9-9-24, CR 2N and DRAM Voltage 1.5. Not sure you'll get to 1600 w/ your CPU....if any problems may be able to do the 8-8-8-24, 2N, 1.5-1.6 at 1333.

[bayourebel]

I also found these settings

DRAM Frequency DDR3-1600, DRAM Timings tCL 9 - tRCD 9 - tRP 9 - tRAS 24 - Command Rate 2, DRAM Voltage 1.50V if not does anyone know correct settings for sure to avoid a headache ? I was told buy a GSkill rep that it would work on this mobo with c3 rev cpu at 1600 but he did not say what settings. Sorry Tradesman I did not remember what settings you posted. What about the CPU/NB Offset voltage ? Can I run 8 GBS ( 2GB X 4 ) on this mb. Thanks

[Tradesman]

The settings I provided (and you listed) are the spec settings. It's best to start with them and go from there. You may need adjustments to the CPU, MC, HT, etc voltages.

[GSKILL TECH]

DDR3-1600 9-9-9-24 1.50V
CPU-NB Voltage +0.1V

or

DDR3-1333 8-8-8-24 1.50V

For a sticker or case badge, email your mailing address to ustech@gskillusa.com and we will get one out to you.

Thank you
GSKILL TECH

[bayourebel]

Thanks for the info

DDR3-1600 9-9-9-24 1.50V
CPU-NB Voltage +0.1V

or

DDR3-1333 8-8-8-24 1.50V

For a sticker or case badge, email your mailing address to ustech@gskillusa.com and we will get one out to you.

Thank you
GSKILL TECH

Thanks for the settings I will try them. I have already been contacted by someone at G Skill about the case badge and they said they are sending me one. The email was the same as yours. Thanks chris