F2-8500CL5D-4GBPQ Not running at rated speeds

[terminashunator]

ASUS P5QL-Pro and F2-8500CL5D-4GBPQ (2Gx2) Will not run at rated speeds stable.

Model of the motherboard:
ASUS P5QL-Pro

Model of the memory:
F2-8500CL5D-4GBPQ (2Gx2) 4Gb of RAM total.

Model of the CPU:
Intel Q9550

What is the problem? example: no boot, blue screen, reboot... etc.
The computer is stable running the ram at 400(800) however running at the specified timings from here, 5/6/6/18@ 2.2v and it still will not load into windows, it bluescreens.
Not sure what settings to get it to work correctly.

[Tradesman]

Check and see if you have the latest BIOS 1004, can be found here:

http://www.asus.com/Motherboards/Int..._PRO/#download

Then input the base settings 1066 5-6-6-18 2T 2.0 and try. If needed go to 2.1. If no joy, raise the NB voltage + .05. If still problems can you post your BIOS settings

[terminashunator]

I did it last night. I updated to 1004, 1066 5-6-6-18 2.2v (there is no 2T option but CPUz says it is running 2T). I'll restart and take pictures of the BIOS.
BIOS1
BIOS2
Boot Screen
The Lovely BSOD

[GSKILL TECH]

AI Overclock Tuner - Manual

Write Recovery Time - 8

Thank you
GSKILL TECH

[terminashunator]

Bios
Boot Screen
Yet Another BSOD!
Is this RAM just picky? I have no idea where to go from here =\

[Tradesman]

Have you tried the sticks in slots 2-4 instead of 1-3? or run Memtest on each stick to make sure both are good? These should be fine

[terminashunator]

I ran memtest, with each stick in each slot (10 times total) and got errors each time after a few minutes with those settings, with each stick.

[Tradesman]

Have you tried raising DRAM voltage, say + . 05 and NB voltage + .1

[terminashunator]

Yes, I bumped the ram voltage up +.2 to 2.2v bot not the northbridge, the NB on this board is finicky and is not stable if you bump the voltage up.
I'm pretty sure the Motherboard is the issue here =\
No way two sticks could reproduce the same errors independently.

[Tradesman]

If the NB is at stock basically and finicky about going up at all, sounds flaky, if say 1.1 is stock should be able to jump to 1.35-1.4 safely

[GSKILL TECH]

Any other memory you can test with?

Thank you
GSKILL TECH

[terminashunator]

Afraid not, this is the only DDR2 device I own.
I'm going to ask ASUS if this sort of thing has happened before.

[Tradesman]

Let us know what you hear