Just wondering if its possible to remove the heat spreaderfrom the Ripjaw x series.
The data sheet says they are 40mm high, unfortunatly I am using a Phanteks PH-TC14CS cooler with a RAM clearence of 32mm, This has meant that I only get to use one of the possible 2 fans.
Am asking as the use of a top flow cpu cooler will blast the memory with air so begging the queston is the heat spreader required.
Either that, or bend the cooler , or ditch it and get something different. ( trouble is am limited in height in my case. Hence the top flow cpu cooler.
The data sheet says they are 40mm high, unfortunatly I am using a Phanteks PH-TC14CS cooler with a RAM clearence of 32mm, This has meant that I only get to use one of the possible 2 fans.
Am asking as the use of a top flow cpu cooler will blast the memory with air so begging the queston is the heat spreader required.
Either that, or bend the cooler , or ditch it and get something different. ( trouble is am limited in height in my case. Hence the top flow cpu cooler.
Comment