Bootproblem with SSD

[hasenfuss]

Hello Users,
I've been using a SSD device since nearly one year.
It is a G.SKILL Model=FM-25S2S-115GBPE, FwRev=4.2
But since ca. 3 months I have the issue with starting my Operating System.
In fact sometimes I have to press up to 20 times on the Powerbutton to start U10.04.

-- in the beginning of the day --
Start: I press the Power Button .. then the Notebook shows the Bios Logo
and at this point nothing is going on .. (The Harddrive LED shines steady)
so I hold the Power Button for several seconds and the Notebook goes off
then I go to Start
and this repeats on and on until (The Harddrive LED blinks) and Ubuntu boots ...
--- end --
If I wait for ca. 20-30 seconds after one press on Power Ubuntu beeps and print:
Error 0200 Failure Fixed Disk 0
Error 2110 HD00 Hard Disk Drive Error
Press F1
--
Furthermore important to say ist that if I reboot between short times for example in 2 minutes the system starts immediately.

The good thing is U10.04 starts always but the many attempts are annoying
But I had not used trim on U10.04 because the kernel doesn't support trim.
Since few days I 've installed a newer kernel and I trimmed several times succesfully.

Free drive space is up to 20 percent.

What can I do?

Thanks

[G.SKILL]

try to secure erase the Drive(Parted Magic) and re-install the firmware, let me know if you still have the same problem or not!

[hasenfuss]

Result

Hello,
I did the secure erase with parted magic and installed the firmware 4.2 with WinBootCD again.
Then I installed Ubuntu 12.04.
I finished and It seemed to be fine.
Later I installed all my other programs.
I halted.
I waited ca. 1 h.
Then I started the laptop.
And the same occurred as before.
"Error
0200: Failure Fixed Disk 0
Error
2110: HDD (Hard Disk Drive) read Error
Press F1 to Setup"

What can I do now?

[G.SKILL]

Hi,

not sure if the flash was dead or not, but we can replace another one for you, please contact the RMA department and they will guide you how to replace.