baymavi - vevobahis - mobilbahis - instagram takipçi satın al - instagram takipçi satın al mobil ödeme


No announcement yet.

120GB Phoenix Pro

  • Filter
  • Time
  • Show
Clear All
new posts

  • 120GB Phoenix Pro


    I have recently upgraded to firmware 4.2 and done a clean install of Windows.

    However, when rebooting the system, Windows does not load.

    If I put the system to sleep, I can resume normally, and without issue.

    If I shut down, windows does not load. However, if I shut down and disconnect the power cable for a few seconds, and then boot, windows will load.

    The drive is configured as AHCI in the BIOS.

    What could be causing this issue?

  • #2
    some of our user mention about having problem when using sleep mode, and we reported to sandforce about this kind of issue but still had no solution yet! we will push them again but you may need to go back to 4.0 to stabilize the system, sorry about the inconvenient!