Tweet
hi there everyone, i have been checking in here to find out info on the firmware 1916 for Falcon II, during this time i have seen many threads about how 'bad Gskill' are and blah blah.
none of that here, here is my experiance, and its all good
i downloaded the firmware, followed the intructions sticky'd at the top of the forum,
shut down computer, stuck in jumper, booted into my other Win 7 64 bit install (gaming only) and instaled the update onto my Falcon II from there. no problems no hassle.
i then booted over into my Falcon and re installed Win 7 64 bit from a previos image (12 mins) and here i am.
i would like to thank the Gskill team for their patients in this release, to make sure it was stable and free of bugs, a couple of weeks is nothing, if its going to be 100% release ready.
as far as i am concerned you do a wonderful job here, and long may it continue, i will try and helpout when i can.
here is some screens from my 're-freshed' falcon II
none of that here, here is my experiance, and its all good
i downloaded the firmware, followed the intructions sticky'd at the top of the forum,
shut down computer, stuck in jumper, booted into my other Win 7 64 bit install (gaming only) and instaled the update onto my Falcon II from there. no problems no hassle.
i then booted over into my Falcon and re installed Win 7 64 bit from a previos image (12 mins) and here i am.
i would like to thank the Gskill team for their patients in this release, to make sure it was stable and free of bugs, a couple of weeks is nothing, if its going to be 100% release ready.
as far as i am concerned you do a wonderful job here, and long may it continue, i will try and helpout when i can.
here is some screens from my 're-freshed' falcon II
Comment