Gigabyte GA-P55-UD5 & F3-16000CL9D-4GBRH

[Zeus]

So far looking good overclock wise



But the mobo/mem didn't like the mem multipler at 10 so here is what I have ATM

Advanced Freq settings
CPU ratio - x21
QPI ratio - Auto
BCLK Freq - 200
System mem multiper- 8
PCI express - 100
Extreme mem profile- Disabled

Advanced Mem Settings
Extreme mem profile- Disabled
System mem multiper- 8
Performance Enhanced- Std
Dram timings selectable ? Expert
tRAS - 27
Command Rate (cmd)- 2

Advanced Voltage settings
Load Line Calibration- level1
CPU core- 1.4 volts
QPI Voltage- 1.34V (have tried 1.58V but haven?t tried any higher as it was in the red!)
CPU PLL - 1.9V
Dram Voltage- 1.64V
Everthing else on auto


I have also had the mem at 9 9 9 24 1T last night and it passed Linx 20 passes

What I'm after is the mem at 2000Mhz (with nice tight timings ofc )


TIA

Zeus

[Zeus]

Tried lots of setting all Fail to boot

Have sent for RMA

[jojodancer]

cooling device?

[GSKILL TECH]

Manually set the memory frequency, timings, and voltage. Loosening the timings does not mean they will run fine. In fact, it can make things much worse.

Thank you
GSKILL TECH