GA-X58-UD3R and F3-16000CL9T-6BGTD Config

[smartway]

Config:GA-X58-UD3R and F3-16000CL9T-6BGTD

I just wanted to see if i could get the BIOS settings for the above Ram and motherbard.

I have looked through the other posts to see if i could get the information, but each post I found used slightly differnt ram or board.

If you could include the advanced timing setting, advanced voltage control and anything else you can think of, that would be awesome.

Also the E.M.P is that somthing i should use?

Thanks.

Mike

[GSKILL TECH]

This should help you out...

http://www.gskill.us/forum/showthread.php?t=4423

For DDR3-2000, QPI/VTT Voltage must be manually set. It should need roughly 1.60V, but you should try to find the lowest stable value.

Keep us posted on the results.

Thank you
GSKILL TECH

[smartway]

I have read this post but as glpdx was doing extensive overclocking, i didn't think those settings would be suitable for my setup.

I was hoping to get a stable system with the correct memory settings.

I also noticed from post to post most will recommend disabling the E.M.P function. In the above link glpdx has this enabled.

Just hoping to get a very stable system with just a 3ghz CPU speed.

Thanks for the help.

[GSKILL TECH]

Here's what you need:

In MIT (MB Intelligent Tweaker):

CPU Clock Ratio - 21X
QPI Link Speed - AUTO
Base Clock Control - Enabled
BCLK Frequency - 143
Performance Enhance - Standard
Extreme Memory Profile - Disabled
System Memory Multiplier - 14

Uncore & QPI Features
Uncore Frequency - 4008

DRAM Timing Selectable - Manual

CAS Latency Time - 9
tRCD - 9
tRP - 9
tRAS - 24

Enter these for the other three as well.

Channel A Timing Settings

Advanced Timings
Command Rate - 2

Advanced Voltage Control
Load-Line Calibration - Disabled
QPI/VTT Voltage - 1.60V

DRAM Voltage - 1.600V
Rest to AUTO

Thank you
GSKILL TECH

[smartway]

You Guys Rock

Thanks Guys

I will try these settings tonight. Really really good support.

Glad i decided to get Gskill Ram.

Thanks again.

Mike