If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the
register
link to proceed. To start viewing messages,
select the forum you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
F3-12800CL9D-4GBNQ unstable at 1600 on GA-MA770T-UD3P
Here are my test cases for the combo: http://bit.ly/2i9Ukw (OpenOffice Calc) No one worked!
I was able to send the memory back and bought a different manufacture. I hope this helps somebody to continue the profiling and find a working solutions. I stopped the evaluation because @1333 did not work too. I'm a little bit disapoited with the motherboard manufacture too, because this modules are declared as qualified.
After a few weeks my computer was working fine at 1600, but it didn't last. I'm getting the same problems again. There are some hidden bios settings with CTRL+F1 under memory timings. Would these make a difference?
DQS Training Control [Skip DQS] (next setting is Perform DQS)
CKE Power Down Mode [Disabled]
Memclock tri-stating [Disabled]
Bank Swizzle Mode Enabled
Or should I increase the DRAM Voltage Control again?
Comment