F3-1866C9D-16GSR + GA-Z68X-UD3P-B3 + i7 2600K = NO POST

[DYKEFISH]

Hello,

Just picked me up a 16gb kit F3-1866C9D-16GSR / sniper series and I cant get it to post under xmp2 profile. It will post at the xmp 1 profile at 1600 and runs good. Id really like to get the advertised 1866 if possible. Im running the F8 bios which Is the latest bios just before the uefi bios.

I was running the uefi bios for a short time which I could get mem up to 1866 but that bios hosed my cpu oc so I went back to the award bios which is running my 2600k at 4.5 no probs.

I tried manually setting the mem to the timings on the package and brought up the mem voltage a bit but I can't get it to 1866. any ideas are greatly appreciated.

Thanks!

GA-Z68X-UD3P-B3
F3-1866C9D-16GSR sniper
i7 2600k @ 4.5ghz
WIN 8.1 - 64bit

[supahos]

Did you try to use any uefi bioses other than whichever one goofed your oc? Its possible they fixed it later. The fact the ram works at right speeds at one bios and not the other says yo u might have to pick your oc or your memory. But if your stuck on this bios try raising vccio up a tad as well. As dram voltage... though i think checking many differemt uefi bioses is your best bet

[DYKEFISH]

Thanks for the suggestions, I checked for any other uefi bios's and the one I tried is the only one out and it's beta at that. I also tried bumping the vccio and still could not get it to boot. Any ideas on timings I could try? Thanks again.

[GSKILL TECH]

Post some pictures of EFI with XMP enabled so we can see if anything is incorrect and causing problems.

Thank you
GSKILL TECH