F2-9600cl5d-4gbpi Issue

[ShineDown]

I have the (F2-9600CL5D-4GBPI) (DDR2-1200 PC2-9600) (2048MB x 2) (CL5-5-5-15 2.1V).
And cant get it running at 1200mhz. Currently at 800mhz tried to set the ram to 1066mhz and is unstable.

Heres my specs

Mother Board: M4N82 Deluxe (Asus 980a SLI)
BIOS: 1901
REV: 2.0
CPU:AMD Phenom II x4 965 3.4Ghz @ 4.0Ghz 1.4375V
Socket: AM3

[GSKILL TECH]

Do you have them installed in seperate channels (different color slots)? You may need to oc northbridge, increase CPU-NB and HT Voltages to reach DDR2-1066+.

Thank you
GSKILL TECH

[ShineDown]

Do you have them installed in seperate channels (different color slots)? You may need to oc northbridge, increase CPU-NB and HT Voltages to reach DDR2-1066+.

Thank you
GSKILL TECH

No i have the setup in the dual channel state Both in the same colors.

So my board only supports 1stick in each color?

And can you recommend the cpu-nb and ht voltages max volts so i dont go over it and damage the ram or board.
First time messing with them.

[GSKILL TECH]

For DDR2-800+, it is only supported in different color slots.

Please try the following settings:

AI Overclocking - Manual
DRAM Frequency Control - Manual
DRAM Frequency - 1066
CPU/NB Frequency - 2200
HT Link Speed - (What values do you have for this?)

Memory Configuration (submenu)
DCT Unganged Mode - Enabled
Power Down Enable - Disabled

DRAM Timing Configuration (submenu)
DRAM Command Rate - 2
DRAM Timing Mode - Both
DCT0:
TCL - 5 CLK
TRCD - 5 CLK
TRP - 5 CLK
TRTP - 5 CLK
TRAS - 15 CLK
TWR - 8 CLK

TRFC0 - 127.5
TRFC1 - 127.5

DCT1:
Enter same values as above if using these slots, or if operating full slots.

CPU-NB Voltage - +0.1V
DRAM Voltage - 2.1V
HT Voltage - 1.4V
NB Voltage - 1.2V

Keep me posted on the results.

Thank you
GSKILL SUPPORT