Announcement

Collapse

UNDER CONSTRUCTION: G.Skill Forum

Hello Everyone

The G.Skill Technical forum will be under construction during the month of February. There may be random down time, so we sincerely appreciate your patience and cooperation during this time. We are excited to bring you a more interactive forum to share information. For any technical assistance or issue that may require more attention, please contact us directly via other methods such as email, telephone, social media, NewEgg Chat, and more. Support is available through any avenue you can reach us.

ustech@gskillusa.com
techsupport@gskill.com


We hope for a quick and smooth transition

Thank you for your understanding

GSKILL SUPPORT
See more
See less

HP dx5150 PC Won't Boot With F1-3200PHU2-2GBNT

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • HP dx5150 PC Won't Boot With F1-3200PHU2-2GBNT

    I have an HP dx5150 small form factor PC that will not boot when I install F1-3200PHU2-2GBNT. I have tried one module alone and two together, but I still get the same results.

    My research shows that these modules should work in this computer, but I get beeping and the front LED flashes red 5 times. HP tech support says this is due to "memory is bad or installed incorrectly".

    Below are the specs for memory required by this PC:

    DIMMs
    The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 8GB (1-Gbit Technology) of memory configured in a high-performing dual channel mode.

    The memory available may be limited by the operating system.

    DDR-SDRAM DIMMs
    For proper system operation, if the computer supports DDR-SDRAM DIMMs, the DIMMs must be:
    - industry-standard 184-pin
    - unbuffered PC3200 400 MHz-compliant
    - 2.5 volt DDR-SDRAM DIMMs.
    The DDR-SDRAM DIMMs must also:
    - support CAS latency 3 (CL = 3)
    - contain the mandatory JEDEC SPD information
    In addition, the computer supports:
    - 128Mbit, 256Mbit, 512Mbit, and 1Gbit non-ECC memory technologies
    - single-sided and double-sided DIMMS
    - DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported

    The system will not start if you install unsupported DIMMs.


    Thanks for your help.

  • #2
    They seem to meet the specs, do you have the latest BIOS for the mobo?


    Pls offer comments on support I provide, HERE, in order to help me do a better job here:

    Tman

    Comment


    • #3
      Yes, I have the latest BIOS that is on the HP website for this PC.

      Comment


      • #4
        Must be the "unsupported" DIMMs they mentioned. :/

        Thank you
        GSKILL TECH
        Are you an overclocker? Have screen shots of your OC results? Please post and share your OC experience!

        The new G.Skill Overclocking Section!

        http://www.gskill.us/forum/forumdisplay.php?f=43

        Comment


        • #5
          Guess I'll return them.

          Comment

          Working...
          X