Ausu 990fx r3.0 fx 8350,$gskill ram issues

[GSKILL TECH]

Yes, that can help reset everything

[Mudafugas]

ok so there is a xmp profile for the fallowing ram RAM;G SKILL RIPJAWS F3-14900CL9D-8GBXL
DDR3-1866 CL9-10-9-28 1.5V
XMP PC3-1400 4GBX2

what i am experiencing is my system constantly tells me to close programs as im low on memory i have check allocated memory ect i have came to a conclusion it is a windows 10 issue

not sure what steps to take to accommodate this memory problem perhaps a fresh windows install ?

[GSKILL TECH]

936 x 2 = DDR3-1872

DDR is double data rate so real frequency in MHz * 2 is the effective DDR frequency.

[Mudafugas]

thought i could run my current ram @ 1800 same timings i suppose not


http://dlcdnet.asus.com/pub/ASUS/mb/...419.1480659055

[Mudafugas]

id like to say I have done the fallowing set up with this build set up

MB; AUSU SABERTOOTH 990FX R3.0

CPU; AMD FX 8350 BE

GPU; FXF RX 480 8GB

RAM;G SKILL RIPJAWS F3-14900CL9D-8GBXL
DDR3-1866 CL9-10-9-28 1.5V
XMP PC3-1400 4GBX2

DONE THE FALLOWING

[FX or A Series CPU]

Method 1.

A. Enable DOCP/EOCP in BIOS.
a. If unstable, raise CPU-NB Voltage in addition to the above.

B. Set CPU-NB Voltage +0.05V to +0.1V depending on stability

C. F10, save, exit, and everything should be ready to go.


Method 2.

A. Set DRAM Frequency to DDR3-1866

B. Set DRAM Timings to tCL - tRCD - tRP - tRAS - Command Rate
(that the memory is rated for)

C. Set DRAM Voltage to what the memory is rated for.
(Manually set even if default 1.50V)

D. Set CPU-NB Voltage +0.05V to +0.1V depending on stability

E. F10, save, exit, and everything should be ready to go.

on that note my ram is running @ a freq of 936.15 but with windows memory issues