F3-16000CL9D-4GBTD and GIGABYTE GA-P55-UD3R P55

[Flopboyz]

Last week I bought 2 sets of your

G.SKILL Trident 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 2000 (PC3 16000)
Desktop Memory Model F3-16000CL9D-4GBTD l

from NewEgg for a total of 8 GB

I installed it into the following system:

MB GIGABYTE GA-P55-UD3R P55 RT
CPU INTEL|CORE I7 860 2.8G

The RAM installed and was read by the motherboard and Windows 7 64 bit
at the default 1333 Mhz setting without any problems.

I then proceeded to change the settings to 2000 Mhz as per the
instructions you listed at:

http://gskill.us/forum/showthread.php?t=1953

However, Windows 7 crashes and blue screens every time I load it up.

Any ideas or suggestions on what I can do to have it running stable at
the stated 2000 Mhz level?

Thanks

[GSKILL TECH]

Try the following settings, those in the guide are for the i5 750.

Advanced CPU Features:
CPU Clock Ratio ................................ [17x]
Intel(R) Turbo Boost Tech .................. [Disabled]
CPU Cores Enabled ............................ [All]
CPU Multi Threading .......................... [Enabled]
C3/C6/C7 State Support ................... [Auto]
CPU Enhanced Halt (C1E) ................... [Auto]
C3/C6/C7 State Support .................... [Auto]
CPU Thermal Monitor ......................... [Auto]
CPU EIST Function ............................ [Disabled]
Virtualization Technology ................... [Disabled]
Bi-Directional PROCHOT ..................... [Auto]


Uncore & QPI Features:
QPI Clock Ratio ...........................................AUTO
QPI Link Speed .............................. AUTO
Uncore Clock Ratio...........................AUTO
Uncore Frequency .......................... AUTO
Isonchronous Frequency ..................[Enabled]


Standard Clock Control:
Base Clock (BCLK) Control ................ [Enabled]
BCLK Frequency (MHz) ..................... 167
PCI Express Frequency (MHz) ........... [100]

C.I.A.2 [Disabled]

Advanced Clock Control:
CPU Clock Drive ..............................[800mV]
PCI Express Clock Drive ................... [900mV]
CPU Clock Skew ............................. [0ps]


Advanced DRAM Features:
Extreme Memory Profile (X.M.P) ......... [Disabled]
System Memory Multiplier (SPD) ........ [12.0]
Performance Enhance ...................... [Standard]
DRAM Timing Selectable (SPD) .......... [Expert]

Channel A + B + C

Channel A Timing Settings:
##Channel A Standard Timing Control##
CAS Latency Time ...................... 9
tRCD ....................................... 9
tRP ......................................... 9
tRAS ....................................... 27

##Channel A Advanced Timing Control##

Command Rate (CMD) ................ 2

Advanced Voltage Control:

CPU
Load Line Calibration ................. [Disabled]
QPI/VTT Voltage 1.150v ............ 1.100V [1.190V]
CPU PLL 1.800v ....................... 1.800v [1.900V]

DRAM
DRAM Voltage 1.500v .............. 1.650V

Save and exit, everything should run smoothly after that.

Thank you
GSKILL SUPPORT