64 GB Kit RipJaws (F3-12800CL10Q2-64GBZ) in an ASUS P9X79

[Tradesman]

Sounds good will be looking for an update

[cdub]

Here are my voltage settings (manually set)

CPU VCORE Voltage 1.185
CPU VCCSA Voltage 1.200
DRAM Voltage 1.550
VTTCPU Voltage 1.18750

Primary Timings (manually set)
10
10
10
30
2

Secondary Timings - (All "Auto" set)
DRAM RAS# to RAS# Delay 5
DRAM REF Cycle Time 208
DRAM WRITE Recovery Time 12
DRAM READ to PRE Time 6
DRAM FOUR ACT WIN Time 24
DRAM to READ Delay 6
DRAM Write Latency 8

Much better but will still lock. Where do I go from here?

[Tradesman]

Might try DRAM Ref Cylcle Time higher (maybe 255 or so), I sent an email to try and get what should be a close set of advanced timings for the combo, am awaiting an answer

[cdub]

Thanks tradesman - will bump that up to see if it makes a difference.

EDIT: Bumped it to 255. No perceivable difference. Still got it to lock.

[Tradesman]

Will see if I can get the GSkill folks to take a look, will prob be Mon PM or so

[cdub]

Thanks TMan - Any other things I can try whilst we wait?

[cdub]

Crashed again - didn't expect it not to, no changes since the last time. I went ahead and upped two of the voltages. I now look like this:

Here are my voltage settings (manually set)

CPU VCORE Voltage 1.190
CPU VCCSA Voltage 1.200
DRAM Voltage 1.550
VTTCPU Voltage 1.19375

Primary Timings (manually set)
10
10
10
30
2

Secondary Timings - (All "Auto" set except as noted)
DRAM RAS# to RAS# Delay 5
DRAM REF Cycle Time 255 (Manually Set)
DRAM WRITE Recovery Time 12
DRAM READ to PRE Time 6
DRAM FOUR ACT WIN Time 24
DRAM to READ Delay 6
DRAM Write Latency 8

[Tradesman]

Is 255 the highest it allows?

[GSKILL]

in these case, will suggest if you can replace for another kit, since you had tried lots of adjustment, please exchange with the distributor or send it back for RMA. and it will more easy to see which part cause the issue.

[cdub]

Originally Posted by Tradesman

Is 255 the highest it allows?

It goes up to ~ 500 I think - How high should I try?