Hello,
I recently bought this combo and I'm trying to make sure I get the most of it. Out of the box it runs in 1600Mhz. In the bios I turned on XMP and there was only one profile there called "Profile1" which put the RAM on 2400Mhz. Windows boots but it's unstable and I've seen some file write errors. It crashes with a blue screen after about 5 minutes of running Prime95. If I go back to the original 1600 there are no issues at all.
I tried changing the timings in the bios to the advertised 11-13-13-31 and the voltage to 1.65 but that didn't work either.
Update: Running memtest86 now with both modules just to make sure they're not defective. No errors so far so I believe they're fine.
What am I doing wrong / How do I proceed from here? I specifically bought this set so I can run it in 2400.
Thanks in advance!
I recently bought this combo and I'm trying to make sure I get the most of it. Out of the box it runs in 1600Mhz. In the bios I turned on XMP and there was only one profile there called "Profile1" which put the RAM on 2400Mhz. Windows boots but it's unstable and I've seen some file write errors. It crashes with a blue screen after about 5 minutes of running Prime95. If I go back to the original 1600 there are no issues at all.
I tried changing the timings in the bios to the advertised 11-13-13-31 and the voltage to 1.65 but that didn't work either.
Update: Running memtest86 now with both modules just to make sure they're not defective. No errors so far so I believe they're fine.
What am I doing wrong / How do I proceed from here? I specifically bought this set so I can run it in 2400.
Thanks in advance!
Comment