Announcement

Collapse
No announcement yet.

F3-2400C9D-8GTXD XMP Profiles

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • F3-2400C9D-8GTXD XMP Profiles

    I have 4 sticks of GSkill F3-2400C9D-8GTXD memory and wonder what is the difference in xmp Profile 1 and Profile 2.

  • #2


    Ignore the 3T command rate, it is actually 2T for both profiles.
    Team HardwareLUXX | Show off your G.SKILL products!

    Comment


    • #3
      Thanks for the info. My mb is a Msi Z97 MPower Max AC. I want to tighten the secondary timings. Any recommendations on what numbers to try...

      Comment


      • #4
        I had one of the MSI Z87 models back in the days and it was not that bad with timings at DDR3-2400. So your MPower can probably achieve something similar. For a start, try close in on these, step by step:



        I did miss that the IO-L was one off for CHA-A, ideally it would be 4/4.
        Team HardwareLUXX | Show off your G.SKILL products!

        Comment


        • #5
          Thanks alot.I will give these settings a try...Did you have the memory voltage at stock 1.650 volts.
          Last edited by NIK1; 07-14-2016, 10:57 AM.

          Comment


          • #6
            If i remember correctly it was at 1.65V or a bit lower even.
            Team HardwareLUXX | Show off your G.SKILL products!

            Comment


            • #7
              How did it go, any results?
              Team HardwareLUXX | Show off your G.SKILL products!

              Comment

              Working...
              X