Announcement

Collapse
No announcement yet.

F3-17000CL11D-8GBXL - Z68XP-UD3 - i5 2500K

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • F3-17000CL11D-8GBXL - Z68XP-UD3 - i5 2500K

    Hello everyone,

    I reviewed the forums for my answer but couldn't find one. There are a few things I wanted to review before I get into it.


    Intel i5 2500k 3.3 Ghz LGA1155
    GA-Z68XP-UD3 - BIOS Version F2 06/03/2011 I have not updated the bios because it has been working great thus far
    RAM G.Skill Ripjaws X Series 8Gb (2 X 4Gb) 240-Pin Ddr3 Sdram CL11-11-11-30 2133 1.5V ~ 1.6V X2 = 16GB of RAM
    I recently bought the same RAM but the stickers are different on them. My oldest has 2011, and the new one is 2015. The new one states 1.5 ~ 1.6V. The old one only states 1.5V but I am certain from reading elsewhere that I can set the old RAM to the new RAM timings. The RAM timings I have set are down below.


    I have done a lot of reading as to what my motherboard can support and the max that it can support is 1600Mhz so I have currently set at what it states.


    For All Channels

    Standard Timing
    CAS Latency Time 11
    tRCD 11
    tRP 11
    tRAS 28

    Advanced Timing
    tRC 39
    tRRD 5
    tWTR 6
    tWR 12
    tWTP 24
    tWL 8
    tRFC 208
    tRTP 6
    tFAW 24
    Command Rate(CMD) 1

    I0 Latency 1
    Round Trip Latency 39

    My question is that is my current settings ok? If not I can provide more information

  • #2
    All those values look good.

    Comment


    • #3
      Ok thanks! I am not looking to overclock. I was looking for both sets to talk to each other properly.

      Comment

      Working...
      X