I am attempting to install 2 additional 4BG modules of F3-10666CL9D-8GBRL. Original RAM is same model, but manufacture date Dec 2010.
With all 4 modules installed, I'm getting a hard (like power supply failure) reboot loop when starting Windows. After removing original modules and trying new modules (tried both together and 1 at a time), I'm getting a quick (no power blip) reboot loop when starting Windows.
So far, I have reset CMOS and updated BIOS to lastest version.
After reading this thread regarding double-sided vs single-sided modules, I believe I need to exchange for this:
F3-10666CL9D-8GBNT
At this point, I would like to confirm that I should exchange the modules for the NT version, or is there some BIOS configuring I can look into?
Additionally, does the hard reboot loop w/the full 16GB mean I have a power supply issue as well?
Disclosure: I'm extremely limited in hardware knowledge, and even less so in BIOS.
Thanks in advance for any help you can provide.
With all 4 modules installed, I'm getting a hard (like power supply failure) reboot loop when starting Windows. After removing original modules and trying new modules (tried both together and 1 at a time), I'm getting a quick (no power blip) reboot loop when starting Windows.
So far, I have reset CMOS and updated BIOS to lastest version.
After reading this thread regarding double-sided vs single-sided modules, I believe I need to exchange for this:
F3-10666CL9D-8GBNT
At this point, I would like to confirm that I should exchange the modules for the NT version, or is there some BIOS configuring I can look into?
Additionally, does the hard reboot loop w/the full 16GB mean I have a power supply issue as well?
Disclosure: I'm extremely limited in hardware knowledge, and even less so in BIOS.
Thanks in advance for any help you can provide.
Comment