Hi All,
My current config is :
- Core I7 Extreme Edition 3970X running at 4.94 Ghz OC
- H100i Corsair
- 64 Gb Rip.Jaws G.Skill 2400 Mhz OC
- HD7990
- Asus P9X79 Deluxe (updated with last bios version available in Asus website)
- Thermaltake 1.375 w
- Cosmos 2
To achieve the clock 4.94 Ghz, I just run the software Turbo Evo in Extreme mode and after a boot/reboot sequencies, the system reaches 4.94 Ghz. By myself, I didn´t any adjustment in Bios. All settings was made by the software.
When I run P95 or another software in order to stress the CPU (full load) I see the clocks lowering. The OC 4.94 Ghz back again only if I stop the P95.
This means that my 4.94 Ghz OC is not "rock solid" enough.
To achieve this 4.94 Ghz speed, my Vcore was automaticaly adjust by Turbo Evo to 1.456 v. I know that voltage is not advised to use.
The temps in RealTempGT (six cores) with OC at 4,94 Ghz is :
- IDLE : about 48 ~ 50 degress after 1 hour power on
- LOAD : running P95 in Small FFT mode about 65 ~ 72 degress
So, the question is : how to maintain a "rock solid" OC at 4.94 Ghz (or maybe 4.5 Ghz ) in order the clock not lowering at the stress use ?
Regards,
Bruno Sena
From Brazil
My current config is :
- Core I7 Extreme Edition 3970X running at 4.94 Ghz OC
- H100i Corsair
- 64 Gb Rip.Jaws G.Skill 2400 Mhz OC
- HD7990
- Asus P9X79 Deluxe (updated with last bios version available in Asus website)
- Thermaltake 1.375 w
- Cosmos 2
To achieve the clock 4.94 Ghz, I just run the software Turbo Evo in Extreme mode and after a boot/reboot sequencies, the system reaches 4.94 Ghz. By myself, I didn´t any adjustment in Bios. All settings was made by the software.
When I run P95 or another software in order to stress the CPU (full load) I see the clocks lowering. The OC 4.94 Ghz back again only if I stop the P95.
This means that my 4.94 Ghz OC is not "rock solid" enough.
To achieve this 4.94 Ghz speed, my Vcore was automaticaly adjust by Turbo Evo to 1.456 v. I know that voltage is not advised to use.
The temps in RealTempGT (six cores) with OC at 4,94 Ghz is :
- IDLE : about 48 ~ 50 degress after 1 hour power on
- LOAD : running P95 in Small FFT mode about 65 ~ 72 degress
So, the question is : how to maintain a "rock solid" OC at 4.94 Ghz (or maybe 4.5 Ghz ) in order the clock not lowering at the stress use ?
Regards,
Bruno Sena
From Brazil
Comment