Hello everyone! I recently purchased all the things I needed to finally build my pc. It came yesterday and I finished building and turned it on. Fans spinning and power led on. As soon as I set up all my peripherals, i plugged everything in and turned everything on. The PC started up fine, monitor started up fine, but monitor says, "HDMI No Signal" and goes into sleep mode. I noticed that the EZ debug leds on my motherboard and I reset my pc. The DRAM light stays on for about 5 seconds then turns off. This is very frustrating because I have switched the RAM stick's slot a couple of times and it still doesn't work. This is also my first build and it is a fresh pc.
SPECS:
EVGA GTX 1050 Ti SC
Intel Pentium G4560
MSI H110M Pro-VD Plus
Seagate Barracuda 1TB
Be quiet! 500W power supply
Corsair 88R Micro-ATX case
G.SKILL Aegis 1x8gb DDR4
MONITOR:
ASUS VS228H-P
PLEASE NOTE: I cannot get into the bios because the PC won't display anything on monitor for any solutions that involve using the BIOS. Thanks!
SPECS:
EVGA GTX 1050 Ti SC
Intel Pentium G4560
MSI H110M Pro-VD Plus
Seagate Barracuda 1TB
Be quiet! 500W power supply
Corsair 88R Micro-ATX case
G.SKILL Aegis 1x8gb DDR4
MONITOR:
ASUS VS228H-P
PLEASE NOTE: I cannot get into the bios because the PC won't display anything on monitor for any solutions that involve using the BIOS. Thanks!
Comment