Announcement

Collapse
No announcement yet.

Fresh PC not sending signal to monitor? RAM light on on EZ debug led. Please Help!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fresh PC not sending signal to monitor? RAM light on on EZ debug led. Please Help!

    Hello everyone! I recently purchased all the things I needed to finally build my pc. It came yesterday and I finished building and turned it on. Fans spinning and power led on. As soon as I set up all my peripherals, i plugged everything in and turned everything on. The PC started up fine, monitor started up fine, but monitor says, "HDMI No Signal" and goes into sleep mode. I noticed that the EZ debug leds on my motherboard and I reset my pc. The DRAM light stays on for about 5 seconds then turns off. This is very frustrating because I have switched the RAM stick's slot a couple of times and it still doesn't work. This is also my first build and it is a fresh pc.

    SPECS:

    EVGA GTX 1050 Ti SC
    Intel Pentium G4560
    MSI H110M Pro-VD Plus
    Seagate Barracuda 1TB
    Be quiet! 500W power supply
    Corsair 88R Micro-ATX case
    G.SKILL Aegis 1x8gb DDR4

    MONITOR:

    ASUS VS228H-P

    PLEASE NOTE: I cannot get into the bios because the PC won't display anything on monitor for any solutions that involve using the BIOS. Thanks!

  • #2
    Try another module to see if it can work better

    You can RMA if you would like

    http://www.gskill.com/en/rma

    Comment

    Working...
    X