No announcement yet.

F3-12800CL7D-4GBECO+Gigabyte GA-890FXA-UD5+AMD Phenom II x4 945

  • Filter
  • Time
  • Show
Clear All
new posts

  • F3-12800CL7D-4GBECO+Gigabyte GA-890FXA-UD5+AMD Phenom II x4 945

    Forgive me if this has already been answered, I searched the forums and tried the settings in the sticky but still haven't been able to figure it out. So here's the deal:

    I have 4x2GB sticks of the RAM mentioned in the title. Everything seems to run fine if I install two sticks in slots 1 and 3 (DDR3_1 and DDR3_3) which according to the manual is Channel_0. I've tested all four sticks in this manner and they work fine. However, when I populate all four slots and fire it up, I get no POST, only some long beeps. Most of my settings are on auto. Are there some settings I should be adjusting to get all four sticks to work?

    Thanks in advance!

  • #2
    It might be worth noting that I was told that overclocking is apparently only supported on one channel; however, I have not overclocked the memory at all. I've set it at 1600 or below.


    • #3
      So you have one module in blue and the other in white? DDR3_1 closest to CPU, and DDR3_3 third slot away from CPU?

      If that's the case, the motherboard is defective. Considering everything is installed properly and CPU socket pins are good.
      Are you an overclocker? Have screen shots of your OC results? Please post and share your OC experience!

      The new G.Skill Overclocking Section!