If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the
register
link to proceed. To start viewing messages,
select the forum you want to visit from the selection below.
Well, the machine works, but I hoped to reach the 1600 goal because theoretically the mother supports it, really this is uncharted territory for me, so tell me you're good?
when i set the ratio to 12. the cpu shut down for a moment and then appear the second image, but it worse, i will unable yo set previous setting, the 1350, because appear the second imagen too, so i put in automatic again. I will try to set 1350 again
I fear that this method is not safe and can lose the machine, it took me quite a while to make it work. After attempting to put the multiplier to 12, did not want to boot the machine even in automatic, appeared blue screen (in fact they were light blue, with problems in the boot) as well as difficulty reading the memory. I've spent my settings from the beginning, but only now notice a problem in the cpu frequency. I see no interest on your part, so excuse from my request, you can close the post.
Comment