Announcement

Collapse
No announcement yet.

F2-8500CL5D-4GBPK + GIGABYTE GA-MA770-UD3P BIOS settings

Collapse
This is a sticky topic.
X
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • F2-8500CL5D-4GBPK + GIGABYTE GA-MA770-UD3P BIOS settings

    These settings can be used for most DDR2-1066 memory packages on this motherboard.

    Make these changes in your BIOS:

    Set Memory Clock - Manual
    Memory Clock - x5.33 1066MHz
    DCTs Mode - Unganged

    System Voltage Control - Manual
    DRAM Voltage - 2.1V

    DRAM Configuration (submenu)
    CAS# Latency - 5
    RAS to CAS R/W Delay - 5
    Row Precharge Time - 5
    Minimum RAS Active Time - 15
    1T/2T Command Timing - 2
    TwTr Command Delay - 4
    Trfc 0 for DIMM1 - 127
    Trfc 2 for DIMM2 - 127
    Trfc1 for DIMM3 - 127
    Trfc3 for DIMM4 - 127

    Write Recovery Time - 8
    Precharge Time - 4
    Row Cycle Time - 27
    RAS to RAS Delay - 4

    Save and exit.

    Thank you
    GSKILL SUPPORT

  • #2
    Hi. how do I set this motherboard and this ram for 4 x 2 gb sticks? (8gb) Thank you.

    Comment


    • #3
      Try this:

      Set Memory Clock - Manual
      Memory Clock - x4.00 800MHz
      DCTs Mode - Unganged

      System Voltage Control - Manual
      DRAM Voltage - 2.0V

      DRAM Configuration (submenu)
      CAS# Latency - 4
      RAS to CAS R/W Delay - 4
      Row Precharge Time - 4
      Minimum RAS Active Time - 12
      1T/2T Command Timing - 2
      TwTr Command Delay - 4
      Trfc 0 for DIMM1 - 160
      Trfc 2 for DIMM2 - 160
      Trfc1 for DIMM3 - 160
      Trfc3 for DIMM4 - 160

      Write Recovery Time - 8 (you can also try 6 to see if the system can support it)
      Precharge Time - 4
      Row Cycle Time - 27
      RAS to RAS Delay - 4

      Let me know how that goes.

      Comment


      • #4
        Thank you again. its working but some of the values don't go exactly where you said. I noticed my motherboard model number doesn't have the P at the end of it and it's V2.0, I don't know if that's why.

        this is the closest I could get the values to what you said.

        Comment


        • #5
          Looks pretty good. Is the system stable?

          Comment


          • #6
            Yes it has been stable so far. thank you again very much

            Comment

            Working...
            X