[SOLVED]Blue Screen G.SKILL F2-8500CL5D-2GBPK + GA-MA78G-DS3H

[Dizzy Devil]

Ok just after installing vista like 30 minutes later i got my first blue screen. its coming up as page fault in non paged area, and getting this stop message :

STOP: 0x00000050 (0xBFC7959E, 0x00000001, 0x82238389, 0x00000002)

i looked up on the internet and it said it was a memory issue. how can i resolve this?

i have a RAIDMAX SMILODON Extreme Black ATX-612WEBP case, GIGABYTE GA-MA78G-DS3H AM2+/AM2 AMD 780G HDMI ATX AMD Motherboard, running Windows Vista x32 bit, and G.SKILL 2GB (2 x 1GB) 240-Pin DDR2 SDRAM DDR2 1066 (PC2 8500) Dual Channel Kit Desktop Memory

[G.SKILL]

so, what's your CPU model?
and did you add memory and nb voltage yet?
please try to add the memory voltage to 2.1v first
thanks


G.S

[Dizzy Devil]

well in my motherboard manual it said it sets it itself but maybe not, how would i set the voltage?

[Dizzy Devil]

btw i have a AMD Phenom 8450 Toliman 2.1GHz 3 x 512KB L2 Cache 2MB L3 Cache Socket AM2+ 95W Triple-Core Processor, an a Western Digital Caviar SE16 WD5000AAKS 500GB 7200 RPM 16MB Cache SATA 3.0Gb/s Hard Drive if u needed to know, an i just built it all.

i went into the BIOs an found where to change it but it only shows like normal, 0.1v, 0.2v, etc.. but nothing up to 2.0 volts or higher

[G.SKILL]

the standard voltage for DDR2 is 1.8v, +0.1v means 1.9v, then +0.3v means 2.1v
for the nb voltage, it should be set to about +0.2v-+0.3v
thanks


G.S

[Dizzy Devil]

thanks for the help