I am trying to install 8GB (4 x 2GB) of F2-8500CL5D-4GBPK in a Gigabyte MoBo GA-EP45-UD3P. CPU is Intel Q660 2.4Ghz and PSU is Antec EA-500D 500W.
I am having a problem with this memory. It can only run in single channel in the slots DDR2_3 and/or DDR2_4. Every time I place them in DDR2_1 and/or DDR2_2, I cannot boot (I get continous short beeps). I tried to increase FSB voltage to 1.5V and DRAM voltage to 2.1V (trying up to 2.27V) without any success....
I tried to check if my MoBo had any short, but results are still the same.
Is there any way to install 8GB of this memory in this Gigabyte board?
Cyber
I am having a problem with this memory. It can only run in single channel in the slots DDR2_3 and/or DDR2_4. Every time I place them in DDR2_1 and/or DDR2_2, I cannot boot (I get continous short beeps). I tried to increase FSB voltage to 1.5V and DRAM voltage to 2.1V (trying up to 2.27V) without any success....
I tried to check if my MoBo had any short, but results are still the same.
Is there any way to install 8GB of this memory in this Gigabyte board?
Cyber
Comment