Wiper.exe does not start properly

[tes]

Dear all,

I am running an Falcon 128 SSD in a X61t thinkpad (Newest Firmware). Unfortunately the transfer rate dropped down shortly after/ during installation to now approx. 100 MB/s.

Running wiper I receive:

"no drive installed proper hardware found"

Any ideas of improving my SSD speed?

Thanks a lot in advance for each supportive idea.

Greetings

[butchconner]

tes,

I assume since you have a laptop, this is the boot drive. I'm no expert here, but wiper should work according to what I've read.

Try running wiper in "Run As Administrator" mode as I suggested in my thread.

Rev