If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the
register
link to proceed. To start viewing messages,
select the forum you want to visit from the selection below.
Ensure you have the latest BIOS, install the sticks, go into BIOS and enable XMP, select the 1600 profile and should be good to go. If any problems after that, back into the BIOS and check the base timings - should be 9-9-9-24 or (25), DRAM voltage at 1.5 and CR (Command Rate) at 2T....if still problems try DRAM voltage at 1.55. Let us know how this goes.
Pls offer comments on support I provide, HERE, in order to help me do a better job here:
Comment