G.Skill F2-8800CL5D-4GBPI,4096MB, 1100MHz

[xplod3r]

I've ordered G.Skill F2-8800CL5D-4GBPI,4096MB, 1100MHz (2x 2GB)
tried them with this motherboard: GigaByte GA-EP45-DS3R

I cannot run the memory in dual channel (except for 800mhz)
is there something i can do, some settings that i need to change so i can still run it in dual channel? or does this combo just not work?

[G.SKILL]

Please update to the latest BIOS first
then, in "DRAM Performance Control," you'll find "Performance Enhance"
Please set it to "Standard"
it should work fine then


G.S

[xplod3r]

I got the latest BIOS, and it was set on standard 800 mhz, it couldn't run any higher...

is it possible to go higher then 800mhz standard?
is it possible to set it to turbo or extreme?

[G.SKILL]

we tested this board and found no problem to run at least DDR2 1066
but you'll have to set the performance enhance to standard first

with the latest bios, it does not boot if it is set to turbo or extreme


G.S

[xplod3r]

It only works @ 800mhz here. What am i doing wrong? I got it on standard already. And cas latencies are 5-5-5-18. What are your exact settings?

You said there were no problems to run at least 1066, is it possible to get to 1100 or more?

[G.SKILL]

you can take this thread for reference:

http://gskill.us/forum/showpost.php?p=316&postcount=13



and to run DDR2 1100 depends on the motherboard, we can't be sure about that
thanks


G.S